1/2-13 UNC Tap Drill — Coarse and Fine
| Thread | Series | TPI | Tap Drill | Decimal Inch | mm equiv. |
|---|---|---|---|---|---|
| 1/2-13 UNC | UNC | 13 | 27/64″ | 0.4219″ | 10.72mm |
| 1/2-20 UNC | UNF | 20 | 29/64″ | 0.453″ | 2-20 UNF: 29mm |
Formula
UNC Tap Drill Formula (75% engagement)
Tap Drill (inch) = Major Diameter − (0.974 ÷ TPI)
1/2-13 UNC: 0.500 − (0.974 ÷ 13) = 0.500 − 0.0749 = 0.4251″ → 27/64″ (0.4219″)
Adjust Drill Size by Material
| Material | Engagement | Drill | Notes |
|---|---|---|---|
| Mild steel | 75% | 27/64″ | Standard — recommended |
| Stainless 304/316 | 65–70% | One size larger | Reduce torque, prevent tap breakage |
| Aluminium | 75–80% | 27/64″ | Standard or slightly smaller |
| Cast iron | 75% | 27/64″ | Straight flute tap |
| Brass | 75% | 27/64″ | Standard |
Tapping Speeds for 1/2-13 UNC
| Material | M2 HSS (RPM) | M35 Cobalt (RPM) | Coolant |
|---|---|---|---|
| Mild steel | 375–626 | 501–802 | Cutting oil |
| Stainless 304 | 125–225 | 175–300 | Sulphurised oil |
| Aluminium | 1503–2255 | 1879–2757 | WD-40 / cutting fluid |
UNC vs UNF — Which to use?
UNC (13 TPI) is the standard choice for most fastening applications — easier to start, more tolerant of dirt and damage. UNF (20 TPI) is used where vibration resistance or thin-wall threads are needed. Both use different tap drill sizes — check the table above.